Una parte della recensione è stata tradotta automaticamente.
Economico, compatto, versatile e potente: ottimo driver per motori passo-passo bipolari, nasce compatibile con hardware RepRap ma è perfetto per qualsiasi tipo di applicazione dove la corrente di pilotaggio del motore non superi i 2.5A. Lo sto utilizzando in miei progetti di vario genere e sono rimasto molto soddisfatto, oltre che della semplicità di utilizzo, anche dell'efficacia dei sistemi di protezione da sovracorrenti, temperatura troppo elevata e cortocircuiti sulle uscite.
Just adjust the vRef to the lowest possible level for your steppers and double the values in EEPROM and you get doubbled the resolution..... -)
I bought these expecting them to be a drop in replacement for the Pololus I've been buying. They are close but with some slight differences: - 1/32 stepping - this was a nice bonus, doubling the resolution of my setup. - The drive current is a lot higher on these. I use 24V and anything over ~10% on the adjustment POT overheats the driver and my steppers. - The POT is back to front (far CCW == 100%). Once you've factored the above into the setup and tuning of the steppers, these work well and are good value.
todo bien, muy buenos
Produto entregue rápido e bem embalado. sem problemas
conforme à la commande. semble de bonne qualité. livraison rapide et conforme
Run steepmotor without noise
receiver with good packed
Pas encorer essayer mais y'a pas de raison
Sono arrivato con alcuni terminali in panne, ma va bene